The professional maintenance work of the valve before and after the production before the welding plays a vital role in the service of the valve. The correct and orderly maintenance will protect the valve, make the valve function properly and extend the valve. life. Valve maintenance work seems to be simple, but it is not. There are often neglected aspects of work.
First, when the valve is greased, the problem of the amount of grease is often ignored. After the grease gun is refueled, the operator selects the valve and the grease injection method to perform the grease filling operation. There are two cases: on the one hand, the amount of grease is less than that of the grease, and the sealing surface is accelerated by the lack of lubricant. On the other hand, excessive fat injection causes waste. There is no accurate calculation of the different valve sealing capacities based on the valve type category. The sealing capacity can be calculated in terms of valve size and type, and a proper amount of grease can be injected reasonably.
Second, when the valve is greased, the pressure problem is often ignored. During the grease injection operation, the grease injection pressure changes regularly in the peaks and valleys. The pressure is too low, the seal leaks or fails, the pressure is too high, the grease injection port is blocked, the seal grease hardens or the seal ring and the valve ball and the valve plate are locked. Usually, when the grease pressure is too low, the injected grease flows into the bottom of the valve cavity, which usually occurs in a small gate valve. On the one hand, the grease injection pressure is too high. On the one hand, the grease injection nozzle is checked. If the grease hole is blocked, the situation is replaced. On the other hand, the grease is hardened.
The cleaning fluid is used to repeatedly soften the failed sealing grease and inject a new grease. . In addition, the sealing type and sealing material also affect the grease filling pressure. Different sealing forms have different grease filling pressures. Generally, the hard sealing grease pressure is higher than the soft sealing.
Third, when the valve is greased, pay attention to the problem that the valve is in the switch position. The ball valve is normally in the open position during maintenance and maintenance. In special cases, the maintenance is turned off. Other valves cannot be discussed in terms of opening. The gate valve must be closed during maintenance to ensure that the grease fills the seal groove along the seal. If it is open, the seal grease will fall directly into the runner or valve cavity, causing waste.
Fourth, when the valve is greased, the problem of grease injection is often ignored. The pressure, grease injection amount and switch position are normal during the grease filling operation. However, in order to ensure the grease filling effect of the valve, it is sometimes necessary to open or close the valve to check the lubrication effect and confirm that the valve ball or the surface of the valve is evenly lubricated.
www.xinbacn.com
